WHY NOT TO Relocate Your IAT Sensor For Better Performance?

The IAT (Intake Air Temperature) Sensor is there to tell the motorcycle computer the temperature of the incoming air. It requires this to compute the correct amount of fuel to add to the mix to give you an efficient fuel/air mixture to run the engine.

The idea behind this mod is that if the computer ‘thinks’ there is cooler and thus denser air coming in it will add more fuel and the result will be more power. This, however, is only a part of the whole picture and this page is written to debunk the myths and warn people from doing mods they don’t fully understand.

Note that this mod is very similar to those eBay “chip” scams that are always popping up. The supposed “chip” will invariably turn out to be nothing more than a resister which modifies the signal coming from the IAT sensor, sending a result that tells engine that the incoming air is cooler and thus denser than it actually is. Faking/spoofing a value that keeps the table locked into a specific temp element and there by trying to eliminate KR ( Knock Retard ) changes.

The modification itself is very simple. You remove the IAT Sensor from the air box and plug the hole left behind. You then extend the wires to place it at the front of the motorcycle in a more direct airflow path. Guys, you only moved the sensor 8 inches in a straight line measurement. See picture below.

The result, however, can be much more than you bargained for. What people fail to mention when this comes up is that there are good reasons for the motorcycle ECU to know the actual temperature of the incoming air and that it doesn’t just make arbitrary decisions based on this information. The computer constantly adjusts the mixture to keep it as close as possible to stoich (which is proper) and give you the best possible combination of power and fuel efficiency.

If you’re thinking then that doing this mod will give you more power at the expense of some fuel efficiency, you’re only partially right. While this will tend to yield a small horsepower increase in the short term, and perhaps even the long term as the carbon build-up increases the compression, over time it will ultimately lead to expensive repairs and lowered overall performance. With the computer unaware of the actual air temperature and thinking it’s much colder than it really is, the engine will be running almost constantly rich. The result with be much reduced gas mileage and a build-up of carbon deposits from unburnt fuel which can foul spark plugs and destroy the valve seats.

The trivial gains from this are in no way worth the troubles that can be caused. You’re better off spending a few dollars on a real mod and sleeping better knowing you’re not destroying your BMW S1000RR.